HPA-Faip M 928 ROYAL Uso Y Mantenimiento página 78

3 • Lower bead mounting (fig. 26)
- Place the bottom bead of the tyre underneath
the tool and at the same time apply a little
pressure to the tyre by hand while starting to
rotate the wheel (pedal 15) for easier bead
insertion.
- Rotate until tyre mounting is complete.
4 • Upper bead positioning (fig. 27)
- Position the upper tyre bead.
Take care that the tyre does not slip under-
neath the tool.
5 • bring the bead breaking unit closer
6 • Bead breaker disc positioning (fig. 28)
- Lower the bead breaker disc (control 21) (A)
until it is level with the well of the rim and make
enough room for the clamp to be inserted.
78
7 • Upper bead mounting (fig. 29-29a)
- Mount the clamp in the space created by the
bead breaker disc (fig. 28).
- Spin the wheel (pedal 15) to mount the bead
until the clamp is close to the tool.
- For large (over 19") or particularly difficult
wheels, a second clamp may be useful.
26 - Apply further pressure to the tyre (control 21)
and move the tool head to its rest position
(control 13).
- Spin the wheel again (pedal 15) until the clamp
is close to the bead breaker disc and remove
the clamp (E).
- Once mounting is complete, raise the bead
breaker disc (control 21).
27
User Manual M 928 ROYAL
28
29