Publicidad
PROBLEM /
FAULT
The motor is not
1. Faulty motor, power cable or
working properly.
plug.
2. Blown fuses in the electrical
cabinet.
3. No voltage in the mains
system.
4. The motor's thermal circuit
breaker has tripped.
Intervention
1. The motor has overheated.
of the thermal
2. Motor overload caused by
protector
excessive cutting pressure.
3. Motor fault.
Imprecise
1. Calibration of the stoppers (26) is
cutting angle at
incorrect.
0° - 45°.
Imprecision in the
1. Excessive cutting pressure (on
squaring of cut
tubes and pro les).
2. Incorrect blade toothing for the
material being cut.
3. Cutting speed not right for the
workpiece being cut.
4. Incorrect adjustment of the
eccentric and sliding blade
guides. Incorrect positioning of
the workpiece in the clamp.
5. Poor blade tension
The cutting
1. The blade is worn down or the
nish is rough or
teeth are not suitable for the
uneven
thickness of the material being
cut
2. Excessive cutting pressure.
The blade tends
1. Excessive wear on the rubber
to jump out of the
coating of the pulleys.
guides
2. Slipping of the blade on the
pulleys.
TROUBLESHOOTING
EN
PROBABLE CAUSE
103
SUGGESTED REMEDY
1. Have the machine checked by expert
personnel.
DANGER - WARNING
NEVER ATTEMPT TO REPAIR
THE MOTOR YOURSELF: IT COULD BE
DANGEROUS.
2. Check the fuses and replace them
if necessary.
3. Check the mains power system is
present.
4. Release the start button and wait
for the thermal circuit breaker to
reset (a couple of minutes).
1. Check that motor ventilation air uptakes
are not clogged or obstructed.
2. Perform cutting by applying the right
pressure on the workpiece.
3. Have the motor checked by expert
personnel.
1. Perform calibration by slackening the
xing screws and repositioning the
stoppers.
1. Reduce cutting pressure.
2. Check the cutting parameters in the
relative cutting chart.
3. Check adjustment of the blade guide.
4. Check the position of the workpiece and
that it is securely held in the clamp.
5. Check the blade tension.
1. Check the cutting parameters (blade
tooth, cutting speed) in the relative
cutting chart.
2. Reduce cutting pressure.
1. Get the pulleys checked and if
necessary replaced, by expert
personnel.
2. Never use lubricants or coolants of
any kind. Get the pulleys checked
and if necessary replaced, by expert
personnel.
Publicidad
