Brita Redi-Twist USS-335 Manual De Instrucciones página 10

connect to auxiliary faucet
Install Water Storage
Tank
Note: The Tank Ball Valve fitting on the Water
Storage Tank may need to be tightened 3-4 turns to
get a good seal. DO NOT OVERTIGHTEN.
• Apply 2-3 wraps of plumber's tape to
the threads on the nipple at the top of
the Water Storage Tank.
• Locate the Tank Connector. Hand
tighten onto the Water Storage Tank
nipple 3-4 turns, being careful not to
cross thread or over tighten.
• Do not connect the tube at this time.
This will occur later in the assembly.
• Place the Water Storage Tank next
to the Reverse Osmosis Filter System
Assembly. The Water Storage Tank
can be placed upright or on its side.
Use provided mount stand.
10 10
Step 4
materials and tools needed
pressure gauge
000.00
digital air
Adjust air pressure in the tank to between
5 and 7 psi. You will need an accurate digital
air pressure gauge.