Brita Redi-Twist USS-335 Manual De Instrucciones página 12

connect to auxiliary faucet
Install RO Faucet
• Locate and organize your RO Faucet
install parts. See list on page 2.
• Attach 3/8" white tube to RO Faucet Body.
• Route the 3 tubes attached to the RO
Faucet Body through the RO Faucet
Base, but don't connect the RO
Faucet Body to the RO Faucet Base
yet. Then route the 3 tubes through
the hole in the sink until 12" of tubing
remains above the sink. Lay RO
Faucet Body on the counter top.
• Push the toggle bolts on the RO
Faucet Body through the sink hole
until the RO Faucet Body is flat
against the sink surface. Position
the toggle bolts to catch under the
lower surface of the sink or counter.
Ensure that they will not obstruct the
faucet stem from sitting in place. Tighten the toggle bolts until the RO Faucet Base
is mounted loosely to the surface. TIP: Make sure to keep the "wings" of the toggle
bolts free to allow all tubing and faucet stem room. Install the faucet base with the
bolts at 5 & 11 o'clock positions to have the handle positioned at 90 degrees to the
right.
• Firmly mount the RO Faucet Body to the RO Faucet Base by turning 1/4 clockwise
to lock. Ensure the RO Faucet Body Handle is positioned to your liking. TIP: If there
is not enough clearance for the tubing and stem, the toggle wings may need to be
adjusted to create more clearance.
• Turn the RO Faucet Body 1/4 turn counter-clockwise and remove the faucet enough
to tighten the RO Faucet Base toggle bolt screws firmly. DO NOT OVER-TIGHTEN.
• Mount the RO Faucet Body to the RO Faucet Base and turn 1/4 turn clockwise until
it locks.
• Mount the RO Faucet Spout to the RO Faucet Body by screwing spout nut to body.
12
Step 5
<< Step continued from previous page
materials and tools needed
mounting surface
hole
WARNING
3/8" red tube
1/4" red tube
3/8" white tube