Brita Redi-Twist USS-335 Manual De Instrucciones página 11

materials and tools needed
safety glasses drill
Select Location of Reverse Osmosis
Faucet Mounting Hole. You will need
to select the location of the Reverse
Osmosis Faucet. You have three options
to choose from:
• Use an existing sink top hole. This
may be blank. This is for the spray
hose or soap dispenser (must be
between 1-3/8" and 1-5/8" in
diameter).
• Drill a new hole in the sink.
• Drill a new hole in the countertop
next to the sink.
• Determine where you are going to install your RO Faucet Body.
• Check to ensure the RO Faucet Body will mount flat against the mounting surface.
• Visually review the routing of the tubes from the RO System Head to the RO Faucet
Body. Check to ensure there is adequate tube routing space between the RO Faucet
Body and RO System Head.
• If drilling is needed, drill a 1-3/8" diameter hole in the mounting surface.
DO NOT DRILL THROUGH AN ALL-PORCELAIN OR CAST IRON SINK. If installing on an all-porcelain or cast iron sink, the faucet
must be mounted in a pre-drilled sprayer hole or through the countertop next to the sink. If the countertop must be drilled, make
certain that the area below the drilling location is free of wiring and pipes. Also, make sure that there is sufficient room to make the
proper connections to the bottom of the faucet mount. DO NOT DRILL THROUGH COUNTER TOPS MORE THAN 1" IN THICKNESS
OR COUNTERTOPS MADE OF TILE, MARBLE, GRANITE, OR SIMILAR SUBSTANCE. Consult with a plumber or the countertop
manufacturer for assistance.
USS-335 installation instructions
Step 5
WARNING
Drain
Connector
Cold Water Valve
1/4" white tubing to filter
!
CAUTION
connect to auxiliary faucet
Install RO Faucet
3/8" white tubing to faucet
3/8" red tubing to drain
1/4" red tubing to membrane drain
Step 5 continued on next page >>
Version 2.1I
E
3/8" white tubing to tank
11