Brita Redi-Twist USS-335 Manual De Instrucciones página 16

connect to auxiliary faucet
Sanitize, Test and
Purge System
Note: The bleach must be completely removed
from system before drinking RO water. See purging
instructions below.
Sanitize the System
Sanitizing is recommended immediately
after installation of the RO Filter System
Assembly. It's also recommended after
servicing inner parts. It is important that
the person installing or servicing the
system have clean hands while handling
inner parts of the system. Complete the
following steps to sanitize the system.
• Make sure water supply to RO Filter System Assembly is off.
• Open the RO Faucet. If Water Storage Tank is not already empty, allow the water to
completely empty.
• Find eyedropper included in package and common household bleach (5.25%).
• Disconnect 3/8" White Plastic Tubing from Water Storage Tank by unscrewing nut
from Tank Connector fitting.
• Add 3 ml. of bleach into open end of Water Storage Tank 3/8" White Plastic
Tubing. Handle bleach according to manufacturer's instructions.
• Reconnect Water Storage Tank and 3/8" White Plastic Tubing to Tank Connector
fitting.
• Sanitizing RO Filter System Assembly will be completed during pressure test and
purging following steps on Page 17.
16
Step 7
materials and tools needed
WARNING
Step 7 continued on next page >>