Brita Redi-Twist USS-335 Manual De Instrucciones página 8

connect to auxiliary faucet
Install RO Drain
Connector
materials and tools needed
safety glasses drill
DRAIN CONNECTOR INSTALLATION
Note: Extra care should be taken when entering drains near dishwashers or food waste disposals, as backflow
may occur through the air gap and cause flooding.
• Remove protective cover from back of foam seal. Knock out center hole and align
holes then attach to drain connector front plate.
• Position the drain connector on the sink drain pipe above the drain trap. Allow
room for drilling. Tighten screws and nuts securely.
• Using the drain connector port as a drill guide, drill a 7/32" hole through the wall of
the drain pipe. DO NOT penetrate the opposite side of the pipe, and be careful not
to damage the side of the drain port fitting.
8
Step 2
CAUTION
FOAM
SEAL
WARNING