Brita Redi-Twist USS-335 Manual De Instrucciones página 26

connect to auxiliary faucet
Use and Care
Brita Reverse Osmosis Filtration System USS-335
®
Usage and quality of water in your incoming water line affect the life of filter cartridges.
Cartridges should be replaced sooner if water pressure at the faucet begins to drop
noticeably or if the filter fails to perform satisfactorily.
After prolonged periods of non-use, it is recommended that the filter system be flushed
thoroughly. Let water run for 10 minutes before using. Note: This will empty the storage
tank.
The Redi-Twist
Changes in taste, odor, and/or flow of the water being filtered indicate that the filter should
be replaced.
Please see the Performance Data Sheet for the certified performance of specific systems
with stated cartridges.
System
USS-335 Reverse Osmosis Filtration System
Replace filters every six months or when
capacity is reached.
Replace membrane every 12 months
or sooner.
Replacement Parts Part Number
WFBAS-300
WFBAS-200
WFBAS-400
WFBAF-400
WFBAF-500
WFBAF-300
WFBAF-350
WFBAF-375
WFBAF-355
WFBAF-425
WFBAH-360
WFBAH-170
WFBAR-100
WFBAT-300
WFBAT-100
26
filters used with this filter system has a limited service life.
TM
Please see page 2 for component illustrations.
Filter Model Numbers
Stages 1 & 3: USF-201 - Carbon Filter
Operating pressure 30-100 psi (207-690 kPa)
Stage 2: USF-205 RO Membrane Filter
Operating pressure 30-100 psi (207-690 kPa)
Also Available in a 2 pack as USFS-2332
Description
Mounting Screws (Package of 2)
Eyedropper
Nitrate Test Strip
Kitchen Faucet Adapter
RO Air Gap Faucet (no tubing attached)
1/4" Plastic Tubing (white)
1/4" Plastic Tubing (red)
3/8" Plastic Tubing (white)
3/8" Plastic Tubing (red)
Drain Connector Assembly
Redi-Twist™ 3 Stage RO Head Assembly (no shroud)
RO Auto Shut-Off Diaphragm and Piston Parts
RO Flow Restrictor
RO Water Storage Tank
RO Storage Tank Fitting