Brita Redi-Twist USS-335 Manual De Instrucciones página 20

Install System/Drain in
Remote Location
materials and tools needed
Install a Remote Drain Point and Air Gap (Remote Location)
You can also run the drain tubing to an existing drain in the house. A floor drain, laundry
tub, standpipe, sump, etc. are suitable drain points. This type of drain is preferred over
the drain connector. Check your local codes. Longer lengths of tubing (see parts list in
manual) may be needed.
Always be sure to provide an air gap between the end of the hose and the drain point.
This will prevent water from backing up into the system. Air gaps are required code in
most areas.
To install a remote drain point, complete the following steps:
• Remove 1/4" Red Plastic Tubing from RO Faucet Body by pulling gently.
• Determine if this length is long enough to reach drain point. If so, insert Restrictor
in end of tubing and then insert this end of tubing into drain port on RO Membrane
Filter.
• If not, replace 1/4" Red Plastic Tubing with an adequate length of tubing to reach
drain point. Then insert Restrictor in end of tubing and then insert this end of tubing
into drain port on RO Membrane Filter. Refer to Step 6 in manual on how to
disconnect and connect tubing.
• Run tubing to drain point and secure at end with a bracket (purchased locally).
Provide a 1-1/2" air gap between end of tube and drain.
• Remove 3/8" Red Plastic Tubing from RO Faucet Body and discard.
• Faucet will not have 1/4" or 3/8" tubing attached to airgap barbs in the RO Faucet
Body for remote installation.
20
3/8" white tubing to faucet
Kitchen
3/8" red tubing Packaged Items
3/8" line to Drain
Faucet
to drain
Adapter Shown in White
Drain
Connector
HOT COLD
1/4" line to Filter 1/4" white tubing t ter
1/4" red tubing to
membrane drain
1/4" line to Faucet
3/8" white tubing
1/4" line to Tank
to tank
Storage Tank
WARNING