VALBERG 14S44 D WAD929C Instrucciones De Uso página 18

B
Using the appliance
Programming the dishwasher
Wash Cycle Table
• The table below shows which programs are best for the levels of food residue on them and
how much detergent is needed. It also show various information about the programs.
• Consumption values and program duration are only indicative except for ECO program.
( ) indicates that the program uses rinse aid in the last rinse.
Detergent
Description of
Program pre/main
cycle
wash
Pre-wash (50 °C)
Wash (65 °C)
4/18g
Rinse
Rinse
Intensive
1 or 2 tabs
Rinse (60 °C)
Drying
Wash (50 °C)
22g
Rinse
Rinse (65 °C)
(*EN60436)
1 or 2 tabs
Drying
Pre-wash (40 °C)
Wash (50 °C)
4/18g
Rinse
1 or 2 tabs
Glass
Rinse (50 °C)
Drying
Wash (55 °C)
22g
Rinse
Rinse (50 °C)
90 min 1 or 2 tabs
Drying
Wash (40°C)
12g
Rinse (40°C)
Rapid 1 or 2 tabs
Rinse (55°C)
NOTE
The ECO program is suitable to clean normally soiled
tableware, that for this use, it is the most efficient program
in terms of its combined energy and water consumption,
and it is used to assess compliance with the EU ecodesign
legislation.
32
Running Energy Rinse
Water (L)
time(min) (kWh)
205 1.549 18.7
198 0.849 11
120 0.902 15.2
90 0.839 11.5
30 0.625 11
EN
B
Saving energy
1. Pre-rinsing of tableware items leads to increased water and energy consumption and is
not recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and water
in the use phase than hand dishwashing when the household dishwasher is used according
to the instructions.
Starting a program
1. Draw out the lower and upper basket, load the dishes and push them back. It is
commended to load the lower basket first, then the upper one.
aid
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page "Product fiche". Make
sure that the water supply is turned on to full pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the Start/Pause button, the
dishwasher will start its cycle.
Changing the program mid-cycle
• A programme can only be changed if it has been running only for a short period of time,
otherwise the detergent may have already been released or the the wash water with
detergent has already been drained. If this is the case, the dishwasher needs to be reset and
the detergent dispenser must be refilled.
To reset the dishwasher, follow the instructions below:
1. Press the Start/Pause to stop the machine, then press Program button for more than
3 seconds, the selected program will be cancel.
2. After the selected program be cancled, you can choice the desired program.
3. Press the Start/Pause button, the dishwasher will start.
Using the appliance
3 sec
33 EN