VALBERG 14S44 D WAD929C Instrucciones De Uso página 13

B
Using the appliance
Display
Intensive
Heavily soiled items include pots and pans. With dried
on food.
ECO
This is the standard program suitable for normally
soiled loads, such as pots, plates, glasses and lightly
soiled pans.
Program
5
indicator Glass
For lightly soiled crockery and glass.
90 min
For normally soiled loads that need quick wash.
Rapid
A shorter wash for lightly soiled loads that do not
need drying.
6
Delay time To show the delay time(3h/6h/9h)
Rinse Aid
If the "
low on dishwasher rinse aid and requires a refill.
Warning
7
indicator
Salt
If the "
low on dishwasher salt and needs to be refilled.
Water softener
• The water softener must be set manually, using the water hardness dial.
• The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
• The more minerals there are, the harder your water is.
• The softener should be adjusted according to the hardness of the water in your area.
• Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
• The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
22
" indicator is lit, it means the dishwasher is
" indicator is lit, it means the dishwasher is
EN
B
Using the appliance
• Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on, press the Programme button for
more than 5 seconds to start the water softener setting mode;
3. Press the Program button again to select the proper setting according to your local
environment, the setting will change in the following sequence: H3->H4->H5->H6->H1->H2;
4. Without operation in 5 seconds or Press the Power button to end the setup model.
WATER HARDNESS
German French British
Mmol/l
dH fH Clarke
0 - 5 0 - 9 0 - 6 0 - 0,94
6 - 11 10 - 20 7 - 14 1,0 - 2,0
12 - 17 21 - 30 15 - 21 2,1 - 3,0
18 - 22 31 - 40 22 - 28 3,1 - 4,0
23 - 34 41 - 60 29 - 42 4,1 - 6,0
35 - 55 61 - 98 43 - 69 6,1 - 9,8
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l
The factory setting: H3
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
1)
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
23
Regeneration
Water softner occurs every X Salt consumption
level program sequence (gram/cycle)
1)
H1- Rapid Light
No regeneration
bright
H2- 90 min Light
10
bright
H3- 90 min,
Rapid Light 5 12
bright
H4- Glass Light
3 20
bright
H5- Glass, Rapid
2 30
Light bright
H6- Glass, 90
1 60
min Light bright
EN
0
9