VALBERG 14S44 D WAD929C Instrucciones De Uso página 22

C
Useful information
3. Wash the arms in soapy and warm water and use a soft
brush to clean the jets.
Caring for the dishwasher
Frost precaution
• Please take frost protection measures on the dishwasher
in winter. Every after washing cycles, please operate as
follows:
1. Cut off the electrical power to the dishwasher at the
supply source.
2. Turn off the water supply and disconnect the water inlet
pipe from the water valve.
3. Drain the water from the inlet pipe and water valve. (Use a
pan to gather the water)
40 EN
C
Useful information
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge
to soak up water in the sump.
After every wash
• After every wash, turn off the water supply to the appliance
and leave the door slightly open for a while so that moisture
and odors are not trapped inside.
Remove the plug
• Before cleaning or performing maintenance, always
remove the plug from the socket.
No solvents or abrasive cleaning
• To clean the exterior and rubber parts of the dishwasher,
do not use solvents or abrasive cleaning products. Only use
a cloth with warm soapy water.
• To remove spots or stains from the surface of the interior,
use a cloth dampened with water an a little vinegar, or a
cleaning product made specifically for dishwashers.
When not in use for a long time
• It is recommend that you run a wash cycle with the
dishwasher empty and then remove the plug from the
socket, turn off the water supply and leave the door of the
appliance slightly open. This will help the door seals to last
longer and prevent odors from forming within the appliance.
41 EN