Publicidad
Idiomas disponibles
Idiomas disponibles
A
Preview of the appliance
LIGHT SOURCE
Light source in this product can only be replaced by qualified professionals.
Please contact after-sales service if the light source fails. The light source shall be removed at the
end of the product's useful life, with sorting and recycling done separately.
Countertop installation
Remove all packing material and accessories. Examine the oven for any damage such as
dents or broken door. Do not install if oven is damaged. Cabinet: Remove any protective film
found on the microwave oven cabinet surface. Do not remove the light brown Mica cover
that is attached to the oven cavity to protect the magnetron.
INSTALLATION
1. Select a level surface that provide enough open space for the intake and/or outlet vents.
30cm
0cm
20cm
20cm
min85cm
8
EN
A
Preview of the appliance
– The minimum installation height is 85cm.
– The rear surface of appliance shall be placed against a wall. Leave a minimum clearance
of 30cm above the oven. A minimum clearance of 20cm is required between the oven
and any adjacent walls.
– Do not remove the legs from the bottom of the oven.
– Blocking the intake and/or outlet openings can damage the oven.
– Place the oven as far away from radios and TV as possible. Operation of microwave
oven may cause interference to your radio or TV reception.
2. Plug your oven into a standard household outlet. Be sure the voltage and the frequency
is the same as the voltage and the frequency on the rating label.
The appliance must not be placed in a cabinet.
WARNING :
Do not install oven over a range cooktop or other heat-
producing appliance. If installed near or over a heat source,
the oven could be damaged and the warranty would be void.
The accessible surface may be hot during operation.
9
EN
Publicidad
