Publicidad
Idiomas disponibles
Idiomas disponibles
Detergent residue in the detergent drawer. (**)
• Detergent is put in wet drawer. >>>Dry the detergent
drawer before putting in detergent.
• Detergent has gotten damp. >>>Keep detergents closed in
an environment free of humidity and do not expose them to
excessive temperatures.
• Water pressure is low. >>>Check the water pressure.
• The detergent in the main wash compartment got wet
while taking in the prewash water. Holes of the detergent
compartment are blocked. >>>Check the holes and clean
if they are clogged.
• There is a problem with the detergent drawer valves.
>>>Call the Authorised Service Agent.
• Detergent might be mixed with the softener. >>>Do not
mix the softener with detergent. Wash and clean the
dispenser with hot water.
• Regular drum cleaning is not applied. >>>Clean the drum
regularly. For this, please see 4.4.2.
Too much foam forms in the machine. (**)
• Improper detergents for the washing machine are being
used. >>>Use detergents appropriate for the washing
machine.
• Excessive amount of detergent is used. >>>Use only
sufficient amount of detergent.
• Detergent was stored under improper conditions. >>>Store
detergent in a closed and dry location. Do not store in
excessively hot places.
• Some meshed laundry such as tulle may foam too much
because of their texture. >>>Use smaller amounts of
detergent for this type of item.
• Detergent is put in the wrong compartment. >>>Put the
detergent in the correct compartment.
• Softener is being taken early. >>>There may be problem in
the valves or in the detergent dispenser. Call the Authorised
Service Agent.
Spin
No Spin
23 / EN
Temperature
Rinse plus
Foam is overflowing from the detergent drawer.
• Too much detergent is used. >>>Mix 1 tablespoonful
softener and ½ l water and pour into the main wash
compartment of the detergent drawer. >>>Put detergent
into the machine suitable for the programmes and
maximum loads indicated in the "Programme and
consumption table". When you use additional chemicals
(stain removers, bleachs and etc), reduce the amount of
detergent.
Laundry remains wet at the end of the programme.
(*)
• Excessive foam might have occurred and automatic foam
absorption system might have been activated due to too
much detergent usage. >>>Use recommended amount
of detergent.
(*) Machine does not switch to spinning step
when the laundry is not evenly distributed
in the drum to prevent any damage to the
machine and to its surrounding environment.
Laundry should be rearranged and re-spun.
(**) Regular drum cleaning is not applied. Clean
the drum regularly. See 4.4.2
A
CAUTION!
• If you cannot eliminate the problem
although you follow the instructions in
this section, consult your dealer or the
Authorised Service Agent. Never try to
repair a nonfunctional product yourself.
Fast
Start/
Prewash
Pause
Time
Cold
Rinse hold
Delay
Washing Machine / User's Manual
Publicidad
