Publicidad
Idiomas disponibles
Idiomas disponibles
8 PERIODIC MANTENANCE OF MOTOR
Intervals
Once a day
or every 8
hours
After first 20
hours
Once a week
or every 50
hours
Monthly or
every 250
hours
9
PERIODIC MAINTENANCE OF FLEXIBLE SHAFT AND POKERS
1.-To do the maintenance job in the transmission and poker, firstly disconnect the motor.
2.-In all maIntenance operations, original parts will be used.
3.-To check the wear of the poker controlling the outside diameter and length of the poker. Replace the
housing or cap when the diameter or length in the least point is less than the specified in the table according
to the model.
4.-Lubricate the shaft every 100 working hours. Refer to utilize grease.
A way to lubricate the shaft is to grasp some grease in the palm of the hand and run the close hand with
the lubricant over the length of the shaft, leaving on the shaft a light coating of the lubricant on the entire
length of the shaft, The recommended quantity is 16 grames per metre. Afer connect to the motor, running
flexible shaft without poker during 5 minutes. Do not overlubricate, it could cause the grease penetrate into
the poker, Do not clean the shaft with solvent.
5.-When the length of the shaft is more than 55 mm than the hose. it is neccesary to repair before producing
a bigger breakdown.
6.-Every 300 hours of working is recommended to change the lubricant of the poker. To change the oil in
the poker dismount the cap. Hold the housing on a vise and tap the cap with a hammer. This will help to
break the seal and to loosen the threads. Take out the old oil and fill the cavity of the cap with a light oil
non-foaming 0W30 or equivalent. Mount according to the recommendations of the following point. If
inspection reveals that the oil is thick, heavy, sticky mixture, then the grease of the flexible shaft has
penetrated into the head, and the seals have to be replaced. Follow the steps of the point 7 to replace it.
7.-To do a maintenance follow the following steps:
- After dismantling the poker.
- Flush the parts with solvent and wipe all part.
KAMEL - FLEXIBLE SHAFT AND POKERS
TDX1m, TDX1-5m, TDX2m, TDX3m, TDX4m, TDX5m, TDX6m
Maintenance
aera
- Check oil level
Motor
- Inspect air filter
- Change engine oil
- Check threaded connections
Motor
- Clean air filter
- Check threaded connections
Motor
- Cleanning cooling system
- Change engine oil
Motor
- Check and adjust setting for carburettor
- Inspect and adjust valve clearance
Motor
- Change vibrator oil
- Clena combustión chamber
- Clean fuel tank and filter
Motor
- Inspect fuel pipe
- Remove dirt and used Grease and replace
Machine
KAMEL - AX25, AX32, AX40, AX48, AX58
Maintenance tasks
rusty components
en
9
Publicidad
