Publicidad
Idiomas disponibles
Idiomas disponibles
- Examine bearings, seals and hex driver. If inspection reveals that grease of transmission has
penetrated into the head, the oil seals need replacement. When replacing seals, mount them
back to back (neoprene seal lips face away from each other).
- The purpose of the seals is to keep the oil of the head in, and the flexible shaft grease out. Be
careful not to damage the polished surface where the seals goes. When the seals are dismounted
it is recommended to change it.
- Fill the cavity of the cap with a light oil non-foaming 0W30 or equivalent.
- Apply sealant before assembling and fix the O ring. Tighten and clean the excess sealant. It is
important all the parts are tightened to avoid water and cement try to get into the head.
8.-After maintenance job and service, all the parts must be assembled correctly.
9.-Every 12 months or more frequently, depending on the usage conditions. It is recommended an
inspection be done by an authorized dealer.
9.1 STORAGE
When the DINGO motor has not been used for long periods of time, it should always be stored in a
clean, dry, stable and protected area.
9.2 TRANSPORTATION
When transporting by vehicles, ensure the DINGO motor is safe against slipping, overturning and
blows.
10 LOCATING MALFUNCIONS
10.1 LOCATING MALFUNCIONS OF THE MOTOR
en
PROBLEM
The motor doesn't work
10.2 LOCATING MALFUNCTIONS OF FLEXIBLE SHAFT AND POCKERS
PROBLEM
The motor works
overload and overheats
Bearing failure
KAMEL - AX25, AX32, AX40, AX48, AX58
10
TDX1m, TDX1-5m, TDX2m, TDX3m, TDX4m, TDX5m, TDX6m
CAUSES/SOLUTIONS
Check the gas level.
Check the gas admission key is open.
Check the de choke position.
Check the engine oil level.
CAUSE / SOLUTION
1.- Head is overlubricated.
2.- Too much Grease in shaft or too little.
3.- Failure of seal and the transmisión grease have gone into
the head or the head oil have gone out.
4.- Head movement is restricted.
5.- Transmission with extreme bents.
6.- Transmission in bad condition, broken hose.
1.- Not enough oil in the head.
2.- The head has been working out of the concrete during a
long time.
3.- Water has penetrated the head.
4.- The housing has recieved strong stroke.
KAMEL - FLEXIBLE SHAFT AND POKERS
Publicidad
