Publicidad
Idiomas disponibles
Idiomas disponibles
General
3.2
Stone formations
1.) The stone formations 1 – 20
shown below are suitable among
others for mechanical installation.
Other stone formations can also be
laid by machines as long as the
stones are packed in the correct
formation ready for the machine to
lay them.
2.) The stone formations 16 – 20 are
suitable for mechanical installation by
the shifting adapter PA (4140.0003).
3.) The stone formations 21 – 25 are
suitable for mechanical installation by
special adapter.
Special adapters SA for installation units 21–24 or similar are available on request (indicate stone formation).
•
The device is only designed for the use specified in this documentation.
•
Every other use is not authorized and is forbidden!
•
All relevant safety regulations, corresponding legal regulations, especially regulations of the
declaration of conformity, and additional local health and safety regulations must be observed.
Prior to every operation the user must ensure that:
•
The equipment is suited to the intended operation
•
the functioning and the working condition of the equipment is examined
•
the load is suitable to be handled.
Any doubts about instructions should be raised with the manufacturer prior to use.
ATTENTION: The use of this device is only permitted in proximity to the ground (→ chapter
"Safety at work" and "Explanation of basic concepts").
Only stone elements with parallel and plane surface are allowed to be picked-up and handled.
Because the gripping good could fall down.
51400035
11 / 35
GB
Publicidad
