Descargar Imprimir esta página

Mitsubishi Electric Mr.Slim SEZ-M25 Manual De Instalación página 5

Ocultar thumbs Ver también para Mr.Slim SEZ-M25:

Publicidad

7
[Fig. 7-1]
8
[Fig. 8-1]
For Power supply
[Fig. 8-2-1]
[Fig. 8-2-3]
Ⓔ Use PG bushing to keep the weight of the cable and external force from being
applied to the power supply terminal connector. Use a cable tie to secure the cable.
Ⓕ Indoor/outdoor unit connecting wire
Ⓖ Tensile force
Ⓗ Use ordinary bushing
Ⓘ Signal receiving unit wiring
S1
S2
S3
S1
S2
S3
Ⓐ Screw holding cover (2pcs)
Ⓑ Cover
8.1
For Power
supply
8.2
[Fig. 8-2-2]
[Fig. 8-2-4]
CN90
Ⓙ Terminal bed for power source and indoor transmission
Ⓚ Indoor/outdoor unit connecting wire
Ⓛ Connecting the signal receiving unit
Connect the signal receiving unit to the CN90 (Connect to the wireless remote
controller board) on the indoor unit using the supplied remote controller wire.
Connect the signal receiving units to all the indoor units.
Ⓐ Air inlet
Ⓑ Air outlet
Ⓒ Access door
Ⓓ Ceiling surface
Ⓔ Canvas duct
Ⓕ Air filter
Ⓖ Inlet grille
Ⓐ Indoor unit
Ⓑ Outdoor unit
Ⓒ Signal receiving unit
Ⓓ Wireless remote controller
Ⓔ Main switch/fuse
Ⓕ Grounding
Ⓐ Terminal bed box
Ⓑ Knockout hole
Ⓒ Remove
S3
S2
S1
5

Publicidad

loading