Pioneer HTZ-BD52 Manual De Instrucciones página 12

12 Before you start
En
Putting the batteries in the
remote control
1
1. Open the rear cover.
2. Insert the batteries (AAA/R03 x 2).
Insert as indicated by the +/* marks into
the battery compartment.
3. Close the rear cover.
Close securely (a click should be heard).
The batteries included with the player
have been provided to allow you to check
product operation and may not last long. We
recommend using alkaline batteries that have
a longer life.
• Do not use or store batteries in direct sunlight or
• Do not use any batteries other than the ones
Press lightly on
this part and slide
into the direction
• When loading the batteries into the remote control,
of the arrow.
• Do not heat batteries, disassemble them, or throw
• Batteries may have different voltages, even if they
• To prevent leakage of battery fluid, remove the
Insert the
negative (*)
side first.
• When disposing of used batteries, please comply
Software update
Product information on this product is provided
on the Pioneer website. Check this website
for update and service information on this
product.
http://www.pioneerelectronics.com
WARNING
other excessively hot place, such as inside a car
or near a heater. This can cause batteries to leak,
overheat, explode or catch fire. It can also reduce
the life or performance of batteries.
Caution
specified. Also, do not use a new battery together
with an old one.
set them in the proper direction, as indicated by
the polarity marks (+ and *).
them into flames or water.
look similar. Do not use different kinds of batteries
together.
batteries if you do not plan to use the remote
control for a long period of time (1 month or more).
If the fluid should leak, wipe it carefully off the
inside of the case, then insert new batteries. If a
battery should leak and the fluid should get on your
skin, flush it off with large quantities of water.
with governmental regulations or environmental
public institution's rules that apply in your country/
area.