Publicidad
Idiomas disponibles
Idiomas disponibles
Speaker setup for HTZ-BD32
Preparing the speakers
1. Connect the wires to the player.
Insert the cables connected to the player to
the same colored connector on the speaker.
Caution
• These speaker terminals carry HAZARDOUS LIVE
voltage. To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.
• Do not connect any speakers other than those
supplied to this system.
• Do not connect the supplied speakers to any
amplifier other than the one supplied with this
system. Connection to any other amplifier may
result in malfunction or fire.
2. Attach the non-skid pads to the base of
each speaker.
Wall mounting the speaker for
HTZ-BD32
All speakers have a mounting hole which can
be used to mount the speaker on the wall.
Before mounting
Remember that the speaker system is heavy
and that its weight could cause the screws
to work loose, or the wall material to fail to
support it, resulting in the speaker falling.
Make sure that the wall you intend to mount
the speakers on is strong enough to support
them. Do not mount on plywood or soft surface
walls.
Mounting screws are not supplied. Use screws
suitable for the wall material and support the
weight of the speaker.
• If you are unsure of the qualities and strength of
• Pioneer is not responsible for any accidents or
Non-skid pads
Caution
the wall, consult a professional for advice.
damage that result from improper installation.
Mounting screw
(not supplied)
5 mm
(0.2 in.)
10 mm
(0.4 in.)
5 mm to 7 mm
(0.2 in. to 0.3 in.)
This hole is used to x the
unit to the speaker stand.
Caution: Do not use this hole
to mount on walls or ceilings.
The speaker may fall resulting
in injury.
Connecting
27
En
2
Publicidad
