Pioneer HTZ-BD52 Manual De Instrucciones página 30

30 Connecting
En
Wall mounting the speaker for
HTZ-BD92HW
Before mounting
• Remember that the speaker system is heavy
and that its weight could cause the screws
to work loose, or the wall material to fail to
support it, resulting in the speaker falling.
2
Make sure that the wall you intend to mount
the speaker on is strong enough to support
them. Do not mount on plywood or soft
surface walls.
• Mounting screws are not supplied. Use
screws suitable for the wall material and
support the weight of the speaker.
Caution
• If you are unsure of the qualities and strength of
the wall, consult a professional for advice.
• Pioneer is not responsible for any accidents or
damage that result from improper installation.
1 Remove the base plates.
The base plates are held in position by the
use of 2-sided tape. While holding the leg in
place, strongly press the base plate in the
direction indicated by the arrow to remove
the base plate. Be careful not to damage
the front speaker while doing this.
2. Use a Phillips screwdriver to remove the
two screws holding the legs to the speaker.
Base plate
Leg
3. Using the two screws removed in step 1,
fasten the wall mounting fixtures to the
speaker.
4. Affix the supplied wire stays to the top of the
unit as shown and collect the cable there.
Press until a "click" is
heard.
5. Mount on wall.
Wall
mounting
screws
(available
commercially)*
6 mm to 8 mm
(0.2 in. to 0.3 in.)
* Wall mounting screws are not included. Purchase
appropriate screws taking into consideration the
type of wall and the weight of the speaker system.
Open two holes in the wall 818 mm (32.2 in.) apart.
818 mm (32.2 in.)
5 mm
(0.2 in.)
10 mm
(0.4 in.)