Stihl RT 4082.1 Manual De Instrucciones página 108

● Reattach screws, washers and nuts to
the battery negative (–) and positive (+)
terminals for safe keeping.
● Install the steering column cover if
necessary. ( 14.17)
Connecting the battery:
● Check the battery voltage before
installing the battery. If the minimum
voltage is not achieved, fully recharge
the battery using a battery charger
before installation.
Minimum voltage: 11,5 V
● Install the battery. ( 14.20)
● If necessary, remove the screw, washer
and nut from the battery.
Attach the terminal connector of red
connection cable (4) to the battery
positive (+) terminal.
Tighten the connection cable with
screw (5), washer (6) and nut (7) using
two (A/F 8) spanners.
Tightening torque: 4 - 5 Nm
Fit cap (3) onto the connection.
106
Attach the terminal connector of black
connection cable (2) to the battery
negative (–) terminal.
Tighten the connection cable with
screw (5), washer (6) and nut (7) using
two (A/F 8) spanners.
Tightening torque: 4 - 5 Nm
14.20 Removing and installing the
battery
Removing the battery:
● Remove the steering column cover.
( 14.16)
● Disconnect the battery. (
Release retaining clasp (1) and remove
battery (2).
● Insert the retaining clasp.
● Install the steering column cover.
( 14.17)
Installing the battery:
● Remove the steering column cover.
( 14.16)
14.19)
Insert battery (1) and insert retaining
clasp (2).
0478 193 9905 B - EN