Publicidad
Idiomas disponibles
Idiomas disponibles
Unscrew and remove retaining nut (1).
Remove discharge chute (2).
Avoid damage to the machine!
Reinstall the discharge chute
immediately after cleaning so that
this is not forgotten.
14.6 Installing the discharge chute
Avoid damage to the machine!
When pushing in, ensure that the
discharge chute fits over the
discharge opening of the mowing
deck on all sides.
Note
When cleaning the discharge chute
or each time it is removed, also
check the level sensor (grass
catcher box) and clean if
necessary.
● Stop the engine. (
12.3)
● Remove the ignition key and keep it in a
safe place.
● Engage the parking brake. (
● Remove the grass catcher box.
(
12.10)
96
● Select the lowest cutting level.
Push discharge chute (1) in to the stop and
position it over the discharge opening in
the mowing deck.
Screw in retaining nut (2) and tighten.
14.7 Mowing blade maintenance
Risk of injury!
Always wear gloves. If you do not
have the necessary expertise or
auxiliary equipment, please always
contact a specialist dealer. (STIHL
recommends STIHL specialist
dealers).
STIHL recommends the use of
original STIHL spare parts.
Never touch the mowing blade
before it has come to a standstill.
Always set down the mowing deck
on a non-slip surface.
Maintenance interval:
Every 25 operating hours
Maintenance operations:
8.10)
● Check the mowing blade wear limits.
● Sharpen the mowing blades if
necessary.
If mowing results deteriorate, the
mowing blade should be sharpened.
Checking the mowing blade wear limits
Risk of injury!
A worn mowing blade may break off
and cause serious injuries. The
instructions for blade maintenance
must therefore always be observed.
Mowing blades are subject to
differing degrees of wear
depending on the location and
duration of use. If you use the
machine on sandy ground or use it
frequently under dry conditions, the
mowing blade will be subjected to
greater loads and will wear more
quickly than normal.
Caution!
Always replace the blade
fastening screw and the retaining
washer when replacing the mowing
blade.
STIHL recommends removing the
mowing deck if the wear limits need
to be checked.
If a suitable lifting platform is
available, the mowing blade wear
limits can also be checked with the
mowing deck installed.
● Remove the mowing deck. (
● Carefully clean the mowing deck and
mowing blades.
0478 193 9905 B - EN
13.1)
Publicidad
