Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: the appliance is designed for the electrical specifications given on the plate applied to the
rear of the appliance; before connecting to the electricity power supply refer to chapter 4.2 connecting
to the electricity supply.
3
CONSIGNING THE APPLIANCE
3.1
TRANSPORTING THE APPLIANCE (see FIG 4)
The TRH12/TRH22 leaves our warehouse carefully packed; packaging consists in:
a)
this manual
b)
food tray
c)
pestle
3.2
CHECKING PACKAGING UPON CONSIGNMENT
When the goods are received proceed with opening the packaging if there are no signs of damage,
and make sure that inside there are all the listed items (see Fig 3).if when the goods are delivered
there are signs of damage to the packaging, agent or courier, and within three days from the date
indicated on the documents draw up a detailed list and report of all damage to the goods. Do not
turn the packed goods upside down! When transporting the package make sure its four main
points are firmly secured (maintain the goods parallel to the ground).
3.3
DISPOSING OF PACKAGING
The various items used for packaging (cardboard, pallets, plastic straps, polyurethane foam) are
normal urban waste products and can be disposed of without difficulty.
If the appliance is destined to countries where are specific standards regarding waste, dispose of
packaging respecting the standards and laws in force.
4
INSTALLING THE APPLIANCE
4.1
APPLIANCE LOCATION
The work surface where the TRH12/TRH22 will be located must be suitable for the size of the
appliance, please refer to the measurements given in Tab 1. The work surface must be level and dry
and at a height of 80 cm from the ground. The appliance must be located in a non-salty environment
with a max humidity value of 75% and with a temperature between 5°C and 35°C; and however,
always in areas and environments that do not cause any type of malfunction to the appliance.
4.2
CONNECTON TO THE ELECTRICITY SUPPLY
TRH12/TRH22 with a single-phase motor
The TRH12/TRH22 comes supply with a 3x1 mm2 long power cable.
Connect with TRH12/TRH22 to a 220-240V/50HZ power supply; At this point makes sure the main
earth circuit functions correctly.
Also check that the information given on the technical data and serial number plate corresponds to
the information given in the accompanying documents.
14
Publicidad
