Publicidad
Decreasing the oscillating frequency:
Turn thumbwheel (3) in clockwise
direction.
The oscillating frequency depends on the appli-
cation and the application tool. Example:
– High oscillating frequency:
Sanding, sawing, using as a rasp, polishing
stone and metal.
– Low oscillating frequency:
Polishing of varnish and veneers.
Working instructions.
Sanding
Typical application: Dry sanding of wood and
metal, especially of smaller surfaces, corners and
edges, as well as hard to reach locations.
Work with the complete surface of the sanding
plate, not only with the tip. Select a high oscillat-
ing frequency. Sand with continuous motion and
light pressure. Applying excessive pressure does
not increase material removal; only the sanding
sheet wears more quickly.
Sawing
Typical application: Sawing of thin steel sheet,
wood and plastic components.
Select a high oscillating frequency. Round saw
blades can be loosened and attached offset, in
order to provide for uniform wear.
Scraping
Typical application: Scraping off old coats of var-
nish or adhesives, removing bonded carpeting,
e. g., on stairs/steps or other small/medium-
sized surfaces.
Select a medium to high oscillating frequency.
Storage
Fully insert the fastening element (6a)
into the tool holder in order to protect it
against damage and contamination.
Engage the quick-clamping lever.
Repair and customer service.
When working metal under extreme
operating conditions, it is possible for
conductive dust to settle in the interior of the
power tool. The total insulation of the power
tool can be impaired. Blow out the interior of
the power tool via the ventilation slots fre-
quently with dry and oil-free compressed air,
and connect a residual current device (RCD) on
the line side.
If the supply cord of this power tool is damaged it
must be replaced by a specially prepared cord avail-
able through the BTI customer service centre.
If required, you can change the following parts
yourself:
– Application tools
– Fastening element (6a)
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for BTI power tools.
In all correspondence and spare parts orders,
please always include the 6-digit order number
given on the nameplate of the machine.
WARNING! Important instructions for connecting a
new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
strain relief
live = brown
neutral = blue
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine, it must
be disposed of safely.
Accessories.
Only use accessories recommended by
BTI.
Warranty and Customer Service.
Each product is thoroughly checked prior to
leaving the factory. Nonetheless, should any
defects occur on the product, please inform
your sales representative, who will then initiate
a retrieval.
The 36 month warranty period begins with the
date of purchase, and proof of which must be
provided for with the original sales receipt. In
this period, we guarantee the following:
– Free-of-cost removal of possible defects
– Free-of-cost replacement of any defective parts
– Free-of-cost expert repair service
Precondition is that the defect is not attributed
to improper handling and that only original
accessory parts were used, that have expressly
been designated by BTI as suitable for operation
with BTI machines.
English - 6
To be fitted
by qualified
professional only
Publicidad
