Stihl MH 710.0 Manual De Instrucciones página 18

English
► If the handlebar cannot be adjusted:
► Do not use the tiller and consult a STIHL
specialist dealer.
The clutch lever for lateral adjustment or
cable is defective.
Main switch
► Start the engine.
► Set the main switch to the 0 position.
The engine cuts out.
► If the engine does not cut out:
► Do not use the tiller and consult a STIHL
specialist dealer.
The main switch is defective.
Throttle lever
► Start the engine.
► Move the throttle lever.
The engine speed changes.
► If the engine speed does not change:
► Do not use the tiller and consult a STIHL
specialist dealer.
The throttle lever is defective.
Gear lever
► Engage gear 0/R, 1 and 2.
► If one of the gears cannot be engaged:
► Do not use the tiller and consult a STIHL
specialist dealer.
The gear lever is defective.
Light switch
► Start the engine.
► Press the On switch.
The headlamp comes on.
► Press the Off switch.
The headlamp goes off.
► If the headlamp does not come on:
► Check whether the headlamp is defective.
► If the headlamp is not working:
► Do not use the tiller and consult a STIHL
specialist dealer.
The light switch is defective.
11 Working with the Cultivator
11.1 Removing the Front Wheel
► Remove the front wheel before starting work,
6.3.2.
11.2 Adjusting the Blade Spur
The blade spur can be adjusted in eight stages.
18
11 Working with the Cultivator
► Loosen bolts (1).
► Detach retaining pin (2) and remove pin (3).
► Move blade spur (4) into the desired position.
► Insert pin (3).
► Push retaining pin (2) through the bore in
pin (3).
► Tighten bolts (1) firmly.
11.3 Using the PTO Drive
► Stop the engine.
► Unscrew screws (1).
► Remove cover (2).
Switching the PTO drive on
WARNING
■ The engine is running if the PTO drive is in
use. If a gear is engaged, the tiller may start
moving uncontrollably. This may result in seri‐
ous injury to people or the tiller running them
over.
► Do not press the clutch lever for reverse
gear.
► Do not engage gears 1 and 2.
► Start the engine.
► Set the gear lever to position 0/R.
► Unlock, press and hold the clutch lever for
self-propulsion.
► Adjust the engine speed using the throttle
lever.
The PTO rotates at the set speed.
Switching the PTO drive off
► Release the clutch lever for self-propulsion.
0478-404-9905-C