Celexon Motor Economy Manual De Instrucciones página 14

IN THE BOX
1x Screen
4x nut
INSTALLATION NOTES
Install the screen in a position that is fully visible to all viewers! The optimum
installation height corresponds to the position of the viewers in the centre of
the screen with the screen fabric extended: eye level = lower third of the screen
surface.
The screen can be installed on the wall/ceiling or hung from the ceiling on clo-
sed ring eyelets plus screwable karabiners (the eyelets are already on the side
cap). For wall or ceiling installation only, the eyelets should be removed in ad-
vance). Please make sure that the metal shims are also used for wall and ceiling
mounting, otherwise safe installation cannot be guaranteed). The enclosed ins-
tallation material is intended for a solid stone wall. If necessary, obtain suitable
mounting material for your installation surface.
MOUNTING ON THE CEILING (VIA EYELETS)*
Attach the eyelets to the two side caps and measure the distance between
them. Mark the points on the ceiling and make sure that the eyelets are aligned
with each other and parallel to the wall. Pre-drill the holes at the markings with
the right diameter drill bit for the hooks and mounting material, fi x them to the
ceiling and hang the screen.
* Electric Economy screens with a cloth width greater / equal
240 cm have the eyelets already integrated in the metal side
cap as a hole. Here, ring eyelets and snap hooks are required.
Make sure that the mounting materials are suffi cient for the
load!
4x Plastic dowels
2x suspension loops
4x Screws 1x IR remote control incl.
Batteries
4