Publicidad
Idiomas disponibles
Idiomas disponibles
POSITIVE STOP SCREW
The position of the positive stop adjustment screw
was set at the factory and normally will not require
readjustment. If the blade is not square to the table, the
positive stop adjustment screw must be re-adjusted.
To adjust refer to Figure 23.
1. Unplug the saw.
2. Loosen the bevel lock knob (B) by turning it
counterclockwise.
3. Using the Phillips end of the blade wrench, adjust
the positive stop adjustment screw (A).
4. Square the blade to the miter table as described
in the section entitled, ALIGN THE BLADE TO THE
TABLE, found on page 13.
5. Re-tighten bevel lock knob (B). Recheck blade-to-
table alignment.
6. The saw has two scale indicators, one on the bevel
scale and one on the miter scale. After squaring
adjustments have been made, it may be necessary
to loosen the indicator screws and reset them to
zero.
NOTE: Use this procedure to check that the blade is square
to the table at 0° and 45° angles.
BEVEL PIVOT
With the bevel lock knob loosened, the control arm of the saw should tilt easily from 0° and 45°. If it does not or if there is
play in the pivot, the saw must be repaired by an AUTHORIZED SERVICE CENTER.
LASER GUIDE
Laser radiation. Avoid direct eye contact
with light source.
Refer to Figure 24.
1. Secure a piece of scrap material to the table surface
using the work clamp or a C-clamp.
2. Plug the saw into the power source and make a
slight cut to score the wood.
3. Release the switch trigger and make sure the blade
comes to a full stop, then raise the saw arm to the
upright position.
4. Unplug the saw. Do not remove the scrap piece.
5. Turn on the laser switch (C). If properly aligned, the
laser should align with the left edge of the partial cut
you just made.
6. If the the laser does not align properly with the cut,
refer to pages 20 and 21 for detailed laser calibration
instruction.
ADJUSTMENTS
18
B
0°
A
FIGURE 23
FIGURE 24
45°
C
Publicidad
