Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous condition.
•
Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting.
•
Do not start the miter saw without checking for interference between the blade and the miter fence. Damage could
result to the blade if it strikes the miter fence during operation of the saw.
•
The saw can tip over if the saw head is released suddenly and the saw is not secured to a work surface. ALWAYS
secure this saw to a stable work surface before any use.
•
If any parts are damaged or missing do not operate this tool until the parts are replaced. Please call Customer Care
Center at 800-223-7278, for instructions.
1. The saw is shipped with the arm secured in the down
position as shown in Figure 3. To release the arm,
push it down, cut the plastic tie and release the lock
pin (A).
2. Lock pin (A) is for storage and transport only. Saw is
not to be locked in down position during cuts.
3. Inspect the tool carefully to make sure no damage
occurred during shipping.
4. Do not discard the packaging material until you have
carefully inspected and satisfactorily operated the
tool.
SUPPORT EXTENSIONS
See Figure 4.
Table extensions have been provided for both the left and
right side of the saw.
To install table extensions:
•
Remove Hex-Socket Cap Screw (D) from the end of
extension (B).
•
Insert the ends of extension (B) into holes in the sides
of the base (C).
•
Thread Hex-Socket Cap Screw (D) into the end of
extension (B). Tighten screw.
•
Repeat for other extension.
MOUNTING THE SAW TO A
STABLE SURFACE
To ensure safe and accurate operation,
this saw should be mounted to a stable
and level surface such as a workbench. To mount the tool
to a stable surface, refer to Figure 5 and do the following:
1. Locate the four mounting holes in the base of the
saw (E).
2. Secure the tool to the mounting surface using 3/8"
diameter machine bolts, lock washers, and hex nuts
(not included). Make sure the bolts are long enough
to accommodate the saw base, lock washers, hex
nuts, and the thickness of the workbench.
3. Tighten all four bolts securely.
4. Check to make sure that the saw is secure before
operation.
ASSEMBLY
E
E
9
A
FIGURE 3
B
C
FIGURE 4
FIGURE 5
D
E
E
Publicidad
