Metal Processing; Health Hazard By Dust; Technical Data; Symbols - Festool ROTEX RO 125 FEQ Manual De Instrucciones

– Prevent liquid polish from entering the ma-
chine. The penetration of liquid polish into the
electric power tool increases the risk of an
electric shock.
– If the power tool is dropped or falls, check
for damage to the machine and sanding pad.
Remove the sanding pad for closer inspection.
Repair damaged parts before using again.
Broken sanding pads and damaged machines
can cause injuries and machine instability.

Metal processing

When processing metal, the following
measures must be taken for safety rea-
sons:
• Install an upstream residual-current circuit-
breaker (FIG, PRCD).
• Connect the tool to a suitable dust extractor.
• Regularly remove dust deposits in the motor
housing.
Wear protective goggles.

Health hazard by dust

Various dust created by power
sanding, sawing, grinding, drilling and other con-
struction activities contains chemicals known (to
the State of California) to cause cancer, birth de-
fects or other reproductive harm. Some examples
of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products,
• Arsenic and chromium from chemically-treat-
ed lumber.
The risk from these exposures varies, depending
on how often you do this type of work.
To reduce your exposure to these
chemicals work in a well ventilated
area and use approved safety equip-
ment, such as dust masks that are
specially designed to fi lter out mi-
croscopic particles. Wash hands after
handling.
O REDUCE THE RISK OF INJURY,
T
USER MUST READ INSTRUCTION MANUAL.

Technical data

ROTEX RO 125 FEQ
Wattage
No load speed
Sanding stroke
Sanding base dia.
Weight
Safety level
Warning of general danger
Read the Operating Instructions/Notes!
Wear protective goggles
Wear ear protection
Wear a dust mask
V Volts
A Amperes
Hz Hertz
W Watt
~ Alternating current
n No load speed
0
Class II Construction
-1
min
rpm Revolutions per minute
Ø Diameter

Intended use

The sanders are designed for sanding and polish-
ing wood, plastic, metal, composite materials,
paint/varnish, fi ller and similar materials.
Do not use with materials containing asbestos.
The tools must not be used when wet or damp,
or operated in a damp environment, for electri-
cal safety reasons. Use this sander only for dry
sanding.
The user bears sole responsibil-
ity for any damage or accidents resulting from
incorrect use.
5
3000 - 6000 rpm
3.6 mm (0.14 in.)
125 mm (4.9 in.)
1.9 kg (4.2 lbs.)

Symbols

500 W
/II