Publicidad
Idiomas disponibles
Idiomas disponibles
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. Before using
for the first time, ask for a practi-
cal demonstration.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Wear safety goggles.
When working, never place a hand or fingers
in front of the saw blade.
Do not work with materials containing asbestos.
Connect machines that are used in the open via
a residual current device (RCD) with an actuat-
ing current of 30 mA maximum. Use only exten-
sion cables that are approved for outdoor use.
Insert the mains plug only when the machine is
switched off.
Always direct the cable to the rear away from
the machine.
Apply the machine to the workpiece only when
switched on.
The cutting path must be free of obstacles both
above and below.
When sawing, the complete surface of the
base plate 12 should securely rest on the ma-
terial. For the working of smaller or thin work-
pieces, use a stable foundation or a saw table
(accessory).
When the cut is completed, switch off the ma-
chine and then pull the saw blade out of the cut
only after it has come to a standstill (danger of
kick-back).
Always switch off the machine and allow to
come to a stop before placing it down.
Do not brake the saw blade to a stop by apply-
ing side pressure after switching off.
Use only sharp, flawless saw blades. Change
any cracked, bent or dull saw blades immedi-
ately.
Never allow children to use the machine.
BTI is only able to ensure perfect functioning of
the machine if the original accessories in-
tended for it are used.
Inserting/Replacing the Saw Blade
Before any work on the machine itself, pull
the plug from the socket!
SDS
Insert the saw blade (teeth in cutting direction)
until it latches in the stroke rod. When inserting
the saw blade, take care that the back of the saw
blade rests in the groove of the guide roller 8.
6
To change the saw blade, push the SDS lever 9
to the front to the stop; this releases the saw
blade and it is ejected.
When changing the saw blade, the ma-
chine should be held so that no persons
or animals can be injured by the ejec-
tion of the saw blade.
Initial Operation
Check for correct mains voltage: The voltage
of the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
Switching On/Off
BTI-ST 110 BE
Brief activation
Switching on: Press On/Off switch 2.
Switching off: Release On/Off switch 2.
Continuous use
Switching on: Press On/Off switch 2 and
Switching off: Press and release
English - 2
The machine is equipped with
a SDS (Special Direct System)
clamping device. This makes
possible
easy
changing of the saw blade
without additional tools.
Note: If the saw blade
cannot be inserted into
the stroke rod 6 be-
cause the slots of the
saw blade holder are
not in the position as
shown, push the SDS
lever briefly to the front
and release.
retain with locking button 3.
On/Off switch 2.
and
quick
Publicidad
