Taking A Continuous Measurement (Min/Max); Taking Delayed Measurement (Timer Function); Using Bluetooth Smart; Fault Codes - Hilti PD-I Manual Del Usuario

2. Use the
or
Alternatively, repeatedly press the
3. Simultaneously press the
measured values saved in the device's data memory.
▶ All measured values are deleted from the device's data memory.
6.3.3

Taking a continuous measurement (min/max)

1. Press the
button and hold it down for 2 seconds to start measuring.
The following values are shown on the display:
• Maximum value
• Minimum value
• Current measured value
2. Press the
button to stop measuring.
The following values are shown on the display:
• Maximum value
• Minimum value
• Last measured value
6.3.4

Taking delayed measurement (timer function)

Delayed measurement (timer function) enables precision measurements over long distances.
Measurement takes place automatically when a countdown time out. This rules out slight movement
of the laser range meter such as can occur when a button is pressed, for example.
The timer function can be used in all the main functions.
The default is 5 seconds.
1. Press the
button and hold it down for 2 seconds.
2. Use the
and
3. Press the
button to confirm the value.
▶ The countdown starts.
6.3.5

Using Bluetooth Smart

Bluetooth Smart enables you to transmit measured values to a mobile device using an app.
You need an app from an official Hilti partner in order to use the function. Before using Bluetooth
Smart, install an appropriate app on you mobile device.
You can find the apps of official Hilti partners by scanning the following QR code:
qr.hilti.com/r9121031
1. Press the
button and hold it down for 2 seconds to switch Bluetooth on.
2. Establish a connection between the mobile device and the laser range meter.
7

Fault codes

Press the or button to hide a fault code.
If a fault code not listed here appears, switch the product off and then on again.
Contact Hilti Service if the fault code re-appears.
Malfunction
204
220
*2222191*
buttons to browse through the measured values in memory.
button.
and buttons and hold them down for 2 seconds to delete the
buttons to set the timer.
Possible cause
Calculation error
General hardware fault.
2222191
Action to be taken
▶ Take the measurement again.
▶ Contact Hilti Service.
English 11