Product Information; Laser Information On The Product; Laser Classification For Class 2 Laser Products; Safety Instructions - Hilti PD-I Manual Del Usuario

1.4 Declaration of conformity
We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration issued by the certification department can be found at the end of
this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
1.5

Product information

products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
There is a label bearing the serial number on the bottom of the battery compartment.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Laser range meter
Generation
Serial no.
1.6

Laser information on the product

Designation and explanation
1.7

Laser classification for Class 2 laser products

The device complies with Laser Class 2 in accordance with IEC 60825-1:2014 /EN 60825-1:2014. These
devices can be used without further protective measures.
Data for classification
Wavelength
Maximum radiant output power for classification
Pulse duration
Pulse repetition frequency
Beam divergence
CAUTION
Risk of injury! Do not direct the laser beam toward persons.
▶ Never look directly into the source of the laser beam. In the event of direct eye contact, close your eyes
and move your head out of the path of the laser beam.
2 Safety
2.1

Safety instructions

2.1.1

General safety measures

▶ Check the product for damage before use. Have damage repaired by Hilti Service.
▶ Check the accuracy of the product if it has been dropped or subjected to other mechanical stresses.
▶ Although the product is designed for the tough conditions of jobsite use, like other measuring instruments
it should be treated with care.
▶ When not in use, products must be stored in a dry, high place or locked away out of reach of children.
▶ The product is not intended for use by children.
▶ Comply with national health and safety requirements.
*2222191*
Class 2 laser.
Do not stare into the beam. Do not direct the beam toward other persons or
toward areas in which other persons, who are not involved in the work with
lasers, may be present.
2222191
PD-I
02
620 nm ... 690 nm
≤ 1 mW
≥ 400
320 MHz
0.16 mrad x 0.6 mrad
English 3