Publicidad
Idiomas disponibles
Idiomas disponibles
English
7
2
Raise the grip of the wing screw (7)
N
to the upright position.
Turn the wing screw
N
counterclockwise as far as stop.
Push the wing screw into the handle
N
support as far as stop and then
screw it down – but do not finally
tighten yet.
Adjust the handlebar (2) so that
N
distance A is no more than 15 cm.
Line up the handlebar at a right
N
angle to the drive tube.
Turn the wing screw clockwise as
N
far as stop.
20
Fold the grip of the wing screw down
N
so that it is flush.
FS 260: Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
12
13
12
Attach the throttle cable (12) to the
N
retainer (13).
Adjusting the Handlebar
Opening the wing screw
Raise the grip of the wing screw to
N
the upright position.
13
Turn the wing screw
N
counterclockwise until the handle
support can be moved.
Move the handlebar to the required
N
position.
FS 260 C, FS 360 C
Publicidad
