Stihl FS 260 C Manual De Instrucciones página 43

Repeat the above procedure as
necessary until both lines reach the
limiter blade on the deflector.
Rotating the spool from one stop to the
next advances about 4 cm (1 1/2 in) of
fresh line.
Replacing nylon line
STIHL PolyCut
A length of nylon line can be fitted to the
PolyCut in place of the cutting blades.
STIHL DuroCut, STIHL PolyCut
WARNING
To reduce the risk of injury, always shut
off the engine before refilling the mowing
head.
Fit nylon line in mowing head as
N
described in the instructions
supplied.
Replacing Cutting Blades
STIHL PolyCut
Always check the mowing head for signs
of wear before installing new cutting
blades.
WARNING
If there are signs of serious wear,
replace the complete mowing head.
The thermoplastic cutting blades are
referred to as "blades" in the following.
FS 260 C, FS 360 C
The mowing head is supplied with
illustrated instructions for replacing the
blades. Keep the instructions for the
mowing head in a safe place.
WARNING
To reduce the risk of injury, always shut
off the engine before installing the
blades.
Remove the mowing head.
N
Replace blades as shown in the
N
illustrated instructions.
Mount the mowing head on the
N
machine.
Inspection and Maintenance
by User
Clamped Area of Handlebar
2
1
Check the freedom of movement of
N
the handlebar (1) in the clamp
moldings (2) at regular intervals.
Handlebar is difficult to move
3
1
Loosen the wing screw (3) just
N
enough for the handlebar to be
moved.
Push the handlebar (1) sideways
N
out of the clamp.
Soak a cloth in a clean, non-
N
flammable cleaning solution – do
not use cleaning agent containing
oil or grease.
English
41