Sony VPH-G70QMG Manual De Instrucciones página 16

Projecting
16
(EN)
3
Turn on the power of the connected equipment.
4
Select the input signal to be projected by pressing the INPUT SELECT
key.
A: To project the RGB, component or the HDTV signal input from the
equipment connected to the INPUT A connectors.
B: To project the signal input from the equipment connected to the
optional interface board other than the IFB-40 installed to the
INPUT B section.
When the PC-1271M Signal Interface Switcher is connected: Set
the SWITCHER/INDEX select switch to SWITCHER and then
select the input with the number keys 1 to 8. If two switchers are
connected, press the SECOND key and then the number key to
select the input from the second switcher.
Note
When you select the input signal connected to the INPUT A or INPUT B section,
be sure to select the correct signal in the SET SETTING menu. If an incorrect
signal is selected, picture may be distorted.
For details, see "The SET SETTING Menu" on page 29 (EN).
5
Adjust the picture.
For details, see "Adjusting the picture" on page 17 (EN).
6
To turn the power off, press the POWER OFF key on the remote
control or on the control panel of the projector, then set the MAIN
POWER switch on the projector to OFF.
To
Turn off the on-screen
display
Cut off the picture
Note
To turn on the projector after the projector has been turned off due to a brief loss
of power, press the POWER ON key on the remote control, or turn off the MAIN
POWER switch so that the STANDBY indicator turns off and then turn on the
MAIN POWER switch.
Press
the STATUS OFF key.
The menus and warning messages
appear even if the OFF key is pressed.
To restore the on-screen display, press
the STATUS ON key.
the MUTING PIC key.
To restore the picture, press the
MUTING PIC key.