Sony VPH-G70QMG Manual De Instrucciones página 23

The INPUT SELECT Menu
The INPUT SELECT menu is used for selecting the
input signal.
Items that can be selected are highlighted in green.
You cannot select the items indicated in white.
V I D E O
INPUT
SELECT
I N P U T - A
I N P U T - B
PIC
CTRL
S W I T C H E R : S W ' E R 1 - 1
INPUT
SETTING
SET
SETTING
INPUT
INFO.
SEL: SET:
ENTER
VIDEO
This item cannot be selected with this projector.
INPUT-A
Selects signal input from the INPUT A connectors.
I N P U T - A
V I D E O
INPUT
SELECT I N P U T - A
I N P U T - B
PIC
CTRL S W I T C H E R : S W ' E R 1 - 1
INPUT
SETTING
SET
SETTING
INPUT
INFO.
SEL: SET:
ENTER EXIT: MENU
Notes
• When the PC-1271M Signal Interface Switcher is
connected to the INPUT A connectors using the 5BNC
cables, INPUT-A cannot be selected.
• If the setting of INPUT A in the SET SETTING menu is
incorrect, the picture may be distorted.
For details, see page 29 (EN).
I N P U T - A
EXIT: MENU
INPUT-B
Selects signal input from the connectors on the signal
interface board (not supplied) installed to the INPUT B
section.
I N P U T - A
V I D E O
INPUT
SELECT I N P U T - A
I N P U T - B
PIC
CTRL S W I T C H E R : S W ' E R 1 - 1
INPUT
SETTING
SET
SETTING
INPUT
INFO.
SEL: SET:
ENTER EXIT: MENU
Notes
• When the PC-1271M Signal Interface Switcher is
connected to the projector via the IFB-40 Signal Interface
Board installed to the INPUT B section, INPUT-B cannot
be selected.
• If the setting of INPUT B in the SET SETTING menu is
incorrect, the picture may be distorted.
For details, see page 29 (EN).
SWITCHER
When the PC-1271M Signal Interface Switcher is
connected to the projector, selects signal input from
the Switcher.
I N P U T - A
V I D E O
INPUT
SELECT I N P U T - A
I N P U T - B
PIC
CTRL S W I T C H E S W E R 1 - 1
S W E R 1 - 2
INPUT
SETTING S W E R 1 - 3
S W E R 1 - 4
SET
SETTING
INPUT
INFO.
SEL: SET: EXIT: MENU
ENTER
You can select SW'ER1-1 to SW'ER2-8 in the pop-up
menu. They are always displayed in green even when
no signal is input.
Note
SWITCHER can be selected only when the IFB-40 Signal
Interface Board is installed to the INPUT B section, or when
5BNC MODE in the SET SETTING menu is set to ON.
23
(EN)