Publicidad
Idiomas disponibles
Idiomas disponibles
Printing Your First Label
The first time you turn on the power, you are asked to select the language and units of
measure. These selections remain set until you change them.
To print a label
1 Enter text to create a simple label.
2 Press PRINT.
3 Press the cutter button to cut the label.
4 Remove the backing from the label to expose the adhesive, and
then attach the label.
Rechargeable Battery Safety Precautions
Battery type: LiPolymer 7.2V 1400mAh 10.08Wh
Inaccurate handling of a lithium-ion polymer rechargeable battery may cause leakage, heat, smoke, an explosion, or fire.
This could cause deterioration of performance or failure. This may also damage the protection device installed in the
battery. This could damage equipment or injure users. Thoroughly follow the instructions below.
Danger
Use the battery only in the Rhino 5200 label maker.
Battery can only be charged while inserted in the label maker using the charging adapter provided (9VDC/2A).
Do not connect directly to an electric outlet or cigarette lighter charger.
Do not store battery close to fire or inside the car where temperature may be over 60°C.
Warning
Stop charging the battery if charging is not completed within three hours.
Caution
Do not use the label maker or battery in a place that generates static electricity.
Use the label maker only at room temperature.
Battery can only be charged within +10°C to 35°C temperature range.
Battery can only be discharged within -10°C to 60°C temperature range.
Use only an authentic DYMO battery.
(Kit model)
3
Split backing
EN
Publicidad
