Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Pass the desired down rod through the decorative cover's centre hole and then introduce it in
the hanging ball again. Make sure the hanging ball is placed in the end with 2 pin holes and 1
screw hole.
Use the screws provided to tighten back the hanging ball to the rod and insert the stop pin and
stop pin's clip again.
Note: Make sure the stop pin is aligned with the slots inside the hanging ball.
Loosen the screws and nuts on the top part of the motor housing and remove the pin and clip
from the down rod.
Slide the down rod through the canopy.
Pass the cables through the down rod. To do it more easily, it is recommended to apply some
rated electrical tape on the end in order to keep them together while passing through the down
rod. Carefully pull from the cables to ensure there is enough cable length to continue with the
assembly.
Introduce the down rod in the motor housing's hole and reinsert the stop pin and stop pin's clip
that were previously removed.
Use 2 screws to fix the canopy to the motor housing.
Warning: The important safety precautions and instructions stated in this manual are not
meant to cover all possible conditions and situations that may occur. Bear in mind that
common sense and caution are necessary factors in the installation and operation of this fan.
Cable connection
The connection cables coming out from the down rod and hanging ball must be connected as
stated below:
Black > motor (live)
Blue > light (live)
White > neutral
Green/Yellow > Ground
Warning: 2 people are needed to carry out the cable connection step. It is suggested that 1
person holds the assembled device while the other one connects the cables.
Canopy assembly
Fig. 7.
Raise the canopy to the mounting bracket, aligning the loosened screws in the mounting
bracket with the holes in the canopy.
Twist the canopy until both screws safely hold the device, reinsert the screws and tighten
them with a screwdriver.
30
ENERGYSILENCEAERO 540
Publicidad
