cecotec ENERGYSILENCE AERO 540 Manual De Instrucciones página 31

Note: For safety reasons, it is suggested that 1 person holds the stepladder during this step.
Blade assembly
Fig. 8.
Remove the 15 blade-fastening screws from the motor housing's lower part.
Introduce the blades in their respective slots, make sure the holes on the blade's ends match
the screw holes and use the screws with washers in place to tighten them.
Make sure they are completely and safely screwed.
LED lamp support
Fig. 9. Fig. 10.
Remove the 3 screws located on the centre of the motor housing's lower part.
Pass the LED panel cables through the LED lamp support's centre hole and connect them. The
LED panel will attach automatically as its screws are magnetic.
Use 3 screws to fix the LED lamp support to the rest of the unit.
Glass shade assembly
Fig. 11.
Introduce the glass shade in the LED lamp support and screw it clockwise.
4. OPERATION
Fig. 12.
1. Speed control (low-medium-high)
2. Summer-winter switch (change blade rotation direction)
3. Light setting
Pull from the chain to turn the fan on and off.
When it is turned off (OFF position), pull from the switch chain until the fan turns on. To turn it
off, pull from the chain again.
When the fan is off:
Pull 1 time for high speed.
Pull 2 times for medium speed.
Pull 3 times for low speed.
Pull 4 times: OFF.
The direction switch located on the fan's body controls the air flow.
Winter function: If it is cold, press the direction switch up.
Blades will move warm air stuck on the top part of the room around.
Summer function: If it is hot, turn the switch down for the blades to
ENGLISH
ENERGYSILENCEAERO 540
31