Pioneer N-50AE Manual De Instrucciones página 13

> Before Start > Part Names
Power On & Initial Setup
Initial Setup
1
2
12
> Install > Initial Setup
BLUE BLINKING
3
> Playback
Supplementary information | Advanced Setup | Others
Starting up: When you press Í/I STANDBY/ON on the
main unit, the STANDBY/ON indicator in the center of the
button slowly flashes blue, then "Hello" is displayed on the
display about 20 seconds later. After this, the display goes
blank, then after the Pioneer logo is displayed, you can start
operating the unit.
Wi-Fi connection settings
When you first turn the power on, the initial setup screen is
displayed automatically, allowing you to easily make Wi-Fi
connection settings.
Initial Setup
Selects the method of network
connection
Wi-Fi
Wired (Exit)
To set, select the item with the cursors on the remote
controller and press ENTER to confirm. To return to the
previous display, press RETURN.
To make Wi-Fi settings, select "Wi-Fi". If you have
connected with an ethernet cable, select "Wired (Exit)" and
confirm. If you select "Wi-Fi", select the method for setting
in the next screen (for example "Scan Networks").
E
N