Pioneer N-50AE Manual De Instrucciones página 24

> Before Start > Part Names
When playing a device connected to the DIGITAL IN
OPTICAL jack, press DIG IN 2 to change the input on this
unit to "Digital In 2".
Digital In 2
When playing a device connected to the DIGITAL IN
COAXIAL jack, press DIG IN 1 to change the input on
this unit to "Digital In 1".
Digital In 1
3. Start play on the player.
0 The digital signals you can input with this unit are as
follows.
(Operation may not be possible depending on the
connected device and environment)
– Signals that can be input through the USB DAC port:
Linear PCM signals with a sampling frequency and
quantization bit rate of up to 384 kHz/32 bit, and DSD
with a sampling frequency up to 11.2 MHz
– Signals that can be input through the DIGITAL IN
OPTICAL/COAXIAL jacks: Linear PCM signals with a
sampling frequency and quantization bit rate of up to
192 kHz/24 bit
> Install > Initial Setup > Playback
Supplementary information | Advanced Setup | Others
E
N
23