Publicidad
Idiomas disponibles
Idiomas disponibles
5 OPERATION & CONTROLS
5030
FIGURE 8A
1. Blade Shifter Handle
(Disengaged)
1
FIGURE 9
1. Drive Shifter Lever
5.6
TO ADJUST DEPTH OF CUT
1. Loosen depth stop lever and adjust depth gauge to
desired setting. Loosen depth control lever and
lower depth control until it rests on depth gauge.
Tighten depth stop and depth control levers. See Fig-
ure 10.
8
All manuals and user guides at all-guides.com
5036
FIGURE 8B
2. Blade Shifter Handle
(Engaged)
5028
3
1
FIGURE 10
1. Depth Stop Lever
2. Depth Gauge
3. Depth Control Lever
NOTE: Numbers on depth gauge DO NOT necessarily
represent the thickness of sod being cut.
2. Engage drive shifter handle.
3. Engage blade shifter handle.
4. Lower blade to preset depth. From operators posi-
tion, lift unit's handle with left hand, raising rear of unit
off the ground, and lower blade to preset depth with
right hand. Tighten all levers.
5. Adjust throttle to full speed.
6. Push clutch lever forward and lower handle.
7. After cutting a short distance, stop and check thick-
ness of sod. Adjust if necessary.
2
5033
Publicidad
