Publicidad
Idiomas disponibles
Idiomas disponibles
10.9 DECALS
TO MOVE WITHOUT POWER:
PLACE DRIVE WHEEL SHIFTER LEVER (IN CENTER OF GEAR CASE COVER) IN CENTER "N" (NEUTRAL) POSITION.
TO MOVE MACHINE UNDER POWER:
1. DISENGAGE CUTTING BLADE SHIFTER LEVER (ON REAR–RIGHT SIDE OF MACHINE) BY ROTATING DOWNWARD.
2. SET DRIVE WHEEL SHIFTER LEVER (IN CENTER OF GEAR CASE COVER) TO THE "H" OR HIGH SPEED POSITION.
3. WITH ENGINE RUNNING, HOLD OPERATOR PRESENT LEVER AGAINST HANDLEBAR AND PUSH CLUTCH LEVER FORWARD TO THE ENGAGED
POSITION.
1. FILL FUEL TANK WITH REGULAR GASOLINE.
2. PULL CLUTCH LEVER BACK TO DISENGAGED POSITION.
3. SET THROTTLE TO 1/2 OPEN POSITION.
4. SET CHOKE AND START ENGINE.
1. MAKE REQUIRED BLADE ADJUSTMENTS.
2. START ENGINE PER INSTRUCTIONS ABOVE AND SET THROTTLE TO FULL SPEED.
3. ENGAGE DRIVE WHEELS BY PLACING SHIFTER LEVER (IN CENTER OF GEAR CASE COVER) TO "L" OR LOW.
4. ENGAGE CUTTING BLADE BY ROTATING SHIFTER LEVER ON REAR RIGHT SIDE OF MACHINE UPWARD.
5. WITH MACHINE TIPPED FORWARD ON FRONT BUMPER AND OPERATOR PRESENT LEVER HELD AGAINST HANDLEBAR, PUSH CLUTCH LEVER
FORWARD, AT THE SAME TIME LOWER THE MACHINE SO BLADE ENTERS THE GROUND.
6. TO STOP MACHINE, PULL BACK FIRMLY ON CLUTCH LEVER, THIS APPLIES A BRAKE.
7. STOP ENGINE BY MOVING THROTTLE LEVER TO "OFF" POSITION.
2
1
12
6
84
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
TRANSPORTING MACHINE
STARTING ENGINE
SOD CUTTING INSTRUCTIONS
10
R
5
11
524540
BLADE ADJUSTMENTS
DEPTH OF CUT
1. LOOSEN UPPER RIGHT HAND LOCKING LEVER. TIP MACHINE FORWARD AND
MOVE CENTER DEPTH CONTROL LEVER TO DESIRED DEPTH. LOCK IN
16
POSITION BY ROTATING LOCKING LEVER CLOCKWISE.
2. LOOSEN DEPTH STOP LOCKING LEVER AT CENTER OF "H" FRAME. RAISE
DEPTH STOP UNTIL IT CONTACTS DEPTH CONTROL LEVER TUBE AND LOCK
THERE SO BLADE CAN BE RETURNED TO SAME POSITION AFTER EACH PASS.
HARD SOIL OPERATION
1. TIP BLADE FORWARD BY LOOSENING LOCKING LEVER (BLACK HANDLE
RIGHT SIDE "H" FRAME). PUSH "H" FRAME FORWARD AS REQUIRED.
2. TIGHTEN LOCKING LEVER AFTER ADJUSTMENT.
HD SOD CUTTER
3
15
9
XX
94
94
d B
dB
dB
8
840697
13
524366
4
7
14
Publicidad
