Publicidad
Idiomas disponibles
Idiomas disponibles
4.1
!
CAUTION
To prevent possible injury to yourself or
bystanders, stand clear when cutting banding.
Banding is under tension and can snap back
when cut.
DO NOT operate this equipment until you have
thoroughly read and completely understand
the controls and operating sections of this
manual. If any part of this manual is not under-
stood, contact an authorized RYAN dealer for
clarification.
To prevent injury, use an adequate lifting
device (i.e., hoist, fork lift, etc.) to remove unit
from pallet.
1. Remove and discard banding securing sod cutter to
pallet.
2. Remove and discard tape securing handle and
clutch control. Remove these parts from unit.
3. Remove sod cutter from pallet using an adequate lift-
ing device.
4. Remove the two screws and lockwashers from
upper rear of gear case and install upper portion of
handle using the hardware previously removed.
Secure the lower end of the handle using one (1)
1/2-13 x 2" screw, lockwasher and nut. See Figure 1.
2
FIGURE 1
1. Hardware
2. Handle
5. Attach clutch control lever to left side of handle
assembly using two (2) 1/4-20 x 5/8" cap screws and
All manuals and user guides at all-guides.com
SET-UP
1
1
5031
locknuts. See Figure 2. Connect the two control links
(Part Nos. 520689 and 521796) together and secure
using two (2) 5/16-18 x 1" flangelock screws and flan-
gelock nuts.
NOTE: The 5/16-18 and the 5/16-24 flangelock nuts are
included in the loose parts bag. BE SURE to use the
correct nut for the proper application.
2
FIGURE 2
1. Clutch Control Lever
2. Throttle Control
6. Locate throttle cable, convoluted tubing and wire
from operator presence control on handle assembly.
Route the convoluted tubing along the handle and
attach to handle with wire tie. Route tubing through
clamp on side of gear case.
7. Connect wire from operator presence control to
engine at location (engine control plate) shown in
Figure 3.
FIGURE 3
1. Operator Presence Wire
SET–UP 4
1
5034
1
5035
5
Publicidad
