cecotec CONGA 890/SLIM Manual De Instrucciones página 24

ENGLISH
SETTING THE TIMER
• The day of the week and time must be properly configured for the timer to work properly.
Check how to set the time and day of the week in the the previous section ("Setting the
current time and day of the week").
• Press the
• Select the day of the week you want the appliance to clean using
• To change to the time, use the
procedure with the minutes: press
• To save this setting, point the remote control towards the cleaner and press OK. The cleaner
will emit a "beep" indicating that the settings have been properly saved. In case the "beep" is
not emitted, the settings have not been saved.
• You have to configure the timer day by day. Repeat the procedure in points 2.2 to 2.5, for the
days you require.
• Once the desired times and days have been set, press
on the display, and the appliance will start cleaning at the selected time.
IMPORTANT: in order to start cleaning at the appointed times automatically, the robot must be
charged and turned on "I".
CANCEL TIMER
• Press the
• Once found, press the
it is so, it has been erased.
• Repeat this procedure to erase the desired days.
• To exit the timer mode, press
NOTE: after changing the remote control's batteries, you will have to set both the time and the timer again.
OPERATION OF THE ACCESSORY FOR LIQUID
*
24 CONGA 890 SLIM
05137_Conga Slim 890_Manual_PE/LI.indd 24
button. The and day of the week icons of the display will start flashing.
button. Use
, then
button and search the day of the week you want to delete with
button for 3 seconds. Check that the time on the display is 00:00. If
again. Check that the deleted days are no longer on the display.
.
to select the desired time. Repeat this
to choose the minutes.
to exit. The chosen days will appear
Container plug
*
Poles
Insertion holes
.
31/5/18 11:25