cecotec CONGA 890/SLIM Manual De Instrucciones página 27

STEADY RED LIGHT:
Nº Beeps
01
02
03
NOTE. If these errpr cannot be solved following the above-mentioned methods, try the options below:
1. Turn off the power switch at the bottom of the machine and restart.
2. If restarting fails to solve the problem, send the machine to the Technical Support Service of
Cecotec for maintenance.
SPECIAL TIPS:
1. Functional disturbances can occur and errors can appear if the voltage of the battery is too
low. In that case the machine should be taken to the charging base manually.
2. The machine has a protection function for excessive discharge and will automatically cut off
the power supply when the battery voltage is too high.
3. The machine will automatically enter the charging mode when the battery runs out of charge.
The charging time may be up to 12h.
7. TECHNICAL SPECIFICATIONS
Model: Conga 890 Slim
Product reference: 05137
Voltage: 10.8 V
Power supply: 17 W
Voltage and frequency: 100-240 V, 50/60 Hz
Made in China | Designed in Spain
CARGADOR
Rated output voltage
Rated output current
MANDO A DISTANCIA
Input voltage
Due to the need for continuous improvement of the products, the company reserves the right to
conduct technology and design changes.
05137_Conga Slim 890_Manual_PE/LI.indd 27
Error
Driving wheel error.
Side brushes error.
Fan error.
19 V
0.6 A
3 V
ENGLISH
Solutions
Rotate the wheel and check if it
gets stuck.
Check if the side brushes get stuck
or are entangled; please clean the
side brushes.
Clear the rubbish in the dust tank
and clean the suction channel.
CONGA 890 SLIM 27
31/5/18 11:25