cecotec CONGA 890/SLIM Manual De Instrucciones página 25

1. Remove the mop from the bottom of the accessory, open the plug of the container, and fill it
with water. You can also add specific cleaning agents in adequate proportions.
2. Attach the mop again to the bottom of the accessory, use the Velcro to fix it.
3. Attach the accessory to the bottom of the vacuum cleaner. Insert the four plastic poles of the
accessory in the four holes you can find on the bottom of the appliance.
4.
Turn on the vacuum cleaner robot. It will vacuum and scrub the floor at the same time.
5. CLEANING AND MAINTENANCE
SIDE BRUSHES CLEANING
Please clean the side brushes when they become dirty; if a side brush is damaged, replace it.
TIPS: both side brushes are identical and can be directly replaced without considering the
correspondence.
DUST TANK AND FILTER CLEANING
Please clean the dust tank and filters immediately after each use, as shown below:
NOTE
• Please check whether there are dust particles in the suction channel and clean it after taking
out the dust tank.
• It is recommended to clean the EPA filter with a hairbrush after use.
• It is recommended to wash the EPA filter with water after it has been used for 15-30 days.
• Please put the cleaned primary and EPA filters in a ventilated and shady places for drying
before use.
• Primary and EPA filters are all replaceable accessories.
SENSORS AND CHARGING TERMINALS CLEANING
Lightly wipe the sensors and charging terminals with dry cleaning tools or soft cloths, as shown
in the figure.
05137_Conga Slim 890_Manual_PE/LI.indd 25
ENGLISH
CONGA 890 SLIM 25
31/5/18 11:25