cecotec CONGA 890/SLIM Manual De Instrucciones página 20

ENGLISH
3. SETUP AND CONFIGURATION
IMPORTANT:
QUICK GUIDE
Setting the charging base
• Connect the adapter to the charging base.
• Place the charging base in a flat surface against the wall.
• Do not put any obstacle on its right or left sides within 1m or in front within 2 m. To keep a smooth
signal reception, do not put a mirror or any other obstacle with a reflecting surface nearby.
• Connect to power supply.
20 CONGA 890 SLIM
05137_Conga Slim 890_Manual_PE/LI.indd 20
Wires and some other sundries scattered on the ground may obstruct the
product, remove them before use.
Please, roll up long hair carpets' tassels or use the product only on short-
hair carpets
Furniture which is lower than 8cm may cause the robot to get stuck,
please raise the furniture if that area needs cleaning.
A protection barrier should be placed on double layer stairs to make sure that
the product works safely in case the free-fall sensors fail.
31/5/18 11:25