dormakaba LA GARD 700 Serie Guia Del Usuario página 38

1. Using the Keypad, input #52 + User ID and Combination + User ID and new Combination + User ID and
new Combination again + <return key> (←).
2. The Keypad will beep three times and flash a green LED once complete. The new combination is set and
will be in effect the next time the User enters their combination.
3.8 Reinstall Keypad
A new Keypad can be installed into a system to replace a damaged unit. This operation can be completed by an
authorized user. An Audit record will be recorded to the lock to indicate which user installed the new keypad.
Once paired, the system returns to regular operation.
Keypads with display screens offer prompts to guide the user through the process. Refer to the Keypad
Installation Guide (Document #7033.0322) for the specific command sequence for both Non-Display and
Display keypads.
Note: The system will only recognize the same Keypad model as before, otherwise it will reject the reinstall
process. If installing a new model of Keypad, all locks attached to the system must be reset/uninstalled and
reinstalled prior to installing the new Keypad.
If the keypad model used for the reinstall does not have the BLE option and the previous keypad was the same
type but with the BLE option (e.g. replacing a 703B with a 703 model) AND the system is configured to require
Dual Credential, then any user required to present Dual Credentials will not be able to perform any actions
associated with their role. Since the Master user is always Single Credential, the Master user can perform the
actions associated with his role. Under these conditions, the Master user will be able to change the Credential
Mode to Single Credential using the keypad. After "fixing" the credential mode, the Credential Mode option will
no longer be shown in the System Menu since the only valid Credential Mode for an Entry without BLE is Single
Credential.
3.9 Change Time/Date/DST
3.9.1 Change Time/Date/DST – Display Keypad
Follow these steps to change the Time/Date/DST on a Display Keypad:
1. Enter an Authorized User ID and Combination.
2. Navigate through the Main Menu and select "Time/Date".
3. Select one of the follow sub-menu options:
a.
"Time Format" – Choose between 24Hr and 12Hr
b.
"Date Format" – Choose between yy_mm_dd, mm_dd_yy, and dd_mm_yy
c.
"Set Time Date" – Input the time and date with the number pad
d.
"Observe DST" – Select either Enable or Disable
4. "Success updated" appears onscreen. The Keypad will beep three times and flash a green LED once
complete.
To effectively use the DST settings, the DST tables must be sent down from the 700 Series Software and the
selected Time Zone must observe Daylight Savings Time. For more information, refer to section
Rules in LA GARD 700 Series Locks".
dormakaba USA Inc. System User Guide 7040.1121 Rev E2 10/22 | 36
3.17 "Time/Date